63" WIDE SRC SYSTEMS LTD MODEL 650 CANTILEVERED DUPLEX TURRET - STOCK

200203 One (1) New SRC Systems Ltd. Model 650 Turret Lead time appx July 2023 Unwind type: Shaft-less pick-up from floor Maximum roll diameter: 50” Maximum roll width: 63” Minimum roll width: 24” Maximum roll weight: 3,500lbs Core holding: 3” + 6” compression chuck Parent roll drive motor: 15Kw servo motor with EtherCat network Tension range: 0.3 - 3pli Tension control: Automatic dancer arm Cam roller: First roller in the material web path fitted with eccentric cams that have +/- 3mm of movement Splice table: Table mounted above the parent roll; the splice table will have 2 x pneumatic clamps Guiding system: BST Ekr500 Web guiding system with ultrasonic sensor Guider travel: +/- 3” End of roll detector: Ultrasonic sensor monitors the parent roll diameter at all times. Underfloor web path: Leading to Rewind section. Rewind section: Duplex dual turret centre wind Main drive: Dual driven 150mm diameter rollers with pneumatically controlled rubber nip. First roller will be hard chromed (this roller will have the nip). Second roller rubber covered. Main drive motor: 5.5Kw inverter motor with Ether-Cat network Maximum machine speed: 2,000ft/ min Slitting type: Shaft driven Rotary shear Min slit width: 2” Female knife shaft: Driven cantilevered hard chrome air shaft for auto positioning female knives Male knives: Mario Cotta pneumatic knife holder with razor attachments Auto female knife position Servo driven linear slide system Knives supplied: 8 x male holder and blades + 10 x female knives Trim Removal (optional): Vacuum Venturi or coreless winder Maximum rewind diameter: 24” Rewind shafts: 4 x 3” slip shafts with 2” wide chucks Rewind motors: 2 x 7.5Kw inverter motors with Ether-Cat network for winding & 1 x 1Kw tail wind-up motor with 10:1 ratio gearbox Lay-on assemblies: 2 x full width assemblies with 60 shore rubber covered lay-on roller and automatic cut off cylinder Laser core positioning: Servo controlled linear guide system with single laser Finished roll push-off Finished roll unloading: Mechanical pivot and rotate to finish the rolls side by side for offloading Operator HMI 10” color touch screen with Wi-Fi connection